Distribution Network: Difference between revisions

During the summer holidays of 1995, [[Owain Davies]] visited the station and stumbled across a flyer from Maxim highlighting their video balanced line drivers and receivers {{unsure|(part number defeats me, I have been on the website but nothing rings bells)}}. At this point, he did not know if he was return to York or not, however he took the flyer away to read at home. He had come across the benefits of balanced line audio ealier on in his Electronics degree and seen it in practice at YSTV where it was used to convey microphone signals down incredibly long pieces of dirty EM infiltrated cable and be amplified at the other end, resulting in crystal clear clarity. The example circuit diagram seemed a remarkable simple solution, just one ic for transmitter and one for the receiver. He returned to York in September of 1995, however he was not due to start his tenancy on a house in Osbaldwick for a week or so and therefore had temporary accommodation in Fairfax House. It was here that the prototype transmitter and receiver were constructed. Trials of the units were performed in the studio of [[G/046]] using twisted pair audio cable. This soon ran out with the units managing to successfully convey the signal, so he resorted any scrap of telephone cable, mains cable, or any cable he could lay his hands on. The signal did eventually deteriate, usually with the picture going black and white due to a dissapearing colour burst (in fact he was amazed by how much the colour burst could reduce in amplitude and colour in the picture remain). He experimented with different resistor and capacitor networks on the feedback loop of the receiver amplifier in an attempt to equalise the high frequency loss of the cable. It was demonstrated to various members of the station using two monitors, one showing before transmission and the other reception with a sea of cable of the floor. The subject under test was given the challenge to determine which monitor was showing the picture that had gone down the various different types of cable. At this point it was decided to inform AV of the idea, since they were the other stakeholder in the network. A meeting was held and they seemed quite interested in the idea and they offered to {{unsure|loan}} the electrical fix installation plans for the University. Their collection was quite comprehensive covering most of the University's buildings, from the colleges down to the VC's bungalow. On these plans were marked the locations of the various contribution points, AV racks and routing information of the cables linking the two.